Calibration Gyroscope

The gyroscope is used to maintain attitude.

Installation

explain how to position the gyro, foam isolation , vibration issue ..

Calibration

Keep in mind, your flight control does this on its own at every reboot. So do not move copter after power until status led stop flashing.

To manual calibrate the neutral of gyroscope sensors, you must tilt the yaw stick left, tilt the pitch stick back while having the throttle stick in minimal position. The multicopter should not move during this stage. However its inclination has no influence. The status LED will blink to confirm this step.

Trim

Use your transmitter trims while in air to correct drift in Acro mode.

Gyroscope sensor axis direction

How the gyroscope sensor axis directions should be:

TILT the MULTI to the RIGHT (left side up):

• GYRO_ROLL goes up.

TILT the MULTI forward (tail up):

• GYRO_PITCH goes up.

Rotating the copter clockwise (YAW):

• GYRO_YAW goes up