However when switching to Angle mode, it drifts backwards and to the right, I thought a simple mounting it level and calibrating the ACC would cure it, it didn't!
I have read that the ACC can be fine adjusted by the following;
- Dis-arm
- Throttle max
- Move the pitch/roll the opposite way to the way it's drifting (not diagonal!).. in my case forward, then left
- Each time it is moved, it adjusts the level by 0.1 degree
If this is correct, it doesn't work for me! having tried it hundreds of times, without any change to the effect (positive or negative)!
The FC I'm using is; http://www.hobbyking.com/hobbyking/stor ... odule.html
The firmware is 2.3 NAV b7
On a side not, I also cannot arm or dis-arm via the sticks, I have to bind it to a switch... may or may not be related!
I thought it may have something to do with the pitch and roll not going high enough to register the adjustment, they are set to;
1015 - Low
1500 - Mid
1985 - High
the thrust is set to;
1065 - Low (this is just high enough to kick the motors into spinning, as advised to do)
1500 - Mid
1985 - High
currently it is a pain in the arse to fly when I'm constantly having to pitch forward and left, to keep it still... remember in Acro mode it holds fairly still, so it's not the trims!
any help is appreciated, as I do respect the fact that everyone on here freely gives their time and advice helping people like me with their problems!
