Motor Arming issue

[Beetlex1968]

Hi Folks !
The Facts: Multiwii 2.3 on an Crius AIOPro V2 Board ....Quad X ( infact Deadcat but thats another Point )

My Problem: When the Motors are disarmed, the Values for the Motors are where i expect them to be: around 1000, but as soon as i arm the Motos they go to 0 and only with 1/2 Throttle ( Throttle command from the remote around 1550 ) they reach idle ( 1000 )

Where do i have to look in the code ?

Cheers

[brewski]

Hi Folks !
The Facts: Multiwii 2.3 on an Crius AIOPro V2 Board ....Quad X ( infact Deadcat but thats another Point )

My Problem: When the Motors are disarmed, the Values for the Motors are where i expect them to be: around 1000, but as soon as i arm the Motos they go to 0 and only with 1/2 Throttle ( Throttle command from the remote around 1550 ) they reach idle ( 1000 )

Where do i have to look in the code ?

Cheers

Check that TX throttle range is 100-2000 with 1500 mid. Also check that you have set min Throttle (1150 a good start) in MWConfig (and save it) as well as calibrating ESCs. Use direct connection with RX or special Do Not Fly calibration sketch in Config.h and then comment it out & reload config.h
I also suggest you check out Beginners Guide to successful first flight in this thread.

[alb1234]

Just in case anyone else checks this thread with an arming problem, one thing that stopped mine working was not having just the throttle to min and yaw to high.
I had yaw AND roll to min which wont arm it. You have to have only yaw(or roll if you've chosen that in the config.h file) and throttle to high and low respectively. I was so happy i solved it yesterday i made a youtube video going through it if you're still not sure... https://www.youtube.com/watch?v=XKcApDD ... e=youtu.be

Also check that the dont arm when not level is commented out in the config.h file