Hello my friends, i had been developing an hexacopter for investigation purposes, i had worked with multiwii from the firsts versions, my problem is, with 2.3 multiwii works normally, but with MultiWii 2.3navi B7 , the hexacopter don't arm, and i dont know why, can you help me?
Thank you!
Hexacopter don't arm on MultiWii 2.3navi B7
Re: Hexacopter don't arm on MultiWii 2.3navi B7
Hello friend, can you give me some help? I am trying for two weeks to put the last revision of multiwii code / Navi b7 code to work on our hexacopter,
we have a tarot 960 with t-motor mn4012-11 400 kv + 15x5.5´´t-motor propeller + Esc t-motor 15A (simonk reflashed) and a hk multiwii pro + Gps from hobbyking + tarot 22000 mah 6s
with the multiwii 2.3 the hexacopter flies without problems, and al function as advise, but with the last revision of multiwii or navi code, it can not arm the motors, i ha tried everything, eeprom clean, bluetooth off / gps off, .. but i can not understand what is the problem, do you have any idea about that?
Thank you very much!
we have a tarot 960 with t-motor mn4012-11 400 kv + 15x5.5´´t-motor propeller + Esc t-motor 15A (simonk reflashed) and a hk multiwii pro + Gps from hobbyking + tarot 22000 mah 6s
with the multiwii 2.3 the hexacopter flies without problems, and al function as advise, but with the last revision of multiwii or navi code, it can not arm the motors, i ha tried everything, eeprom clean, bluetooth off / gps off, .. but i can not understand what is the problem, do you have any idea about that?
Thank you very much!
Re: Hexacopter don't arm on MultiWii 2.3navi B7
What are the Stick End Point values as seen in the MWconf gui??
Most ARMing issues are due to the End Points do not exceed the MINCHECK and MAXCHECK #defines in multiwii.h
Most ARMing issues are due to the End Points do not exceed the MINCHECK and MAXCHECK #defines in multiwii.h