Multiwii pro 2.3

[Dr.Quad]

I've tried several times to upload the 2.3 sketch to my board several times , it uploads fine but when it load it on the GUI it does not show the copter is hooked up on the live graph. But it shows and reacts to stick positions , so it's not at all stable enough to get off the ground. Please help.

[waltr]

Too, too many things could be wrong and not enough info to even start guessing.
Go read the beginners thread in the MW setup sub-forum (This is not the correct forum for this post).

[treym]

I've tried several times to upload the 2.3 sketch to my board several times , it uploads fine but when it load it on the GUI it does not show the copter is hooked up on the live graph. But it shows and reacts to stick positions , so it's not at all stable enough to get off the ground. Please help.

did you select your sensors before uploading the sketch ?
did you adjust the config.h files prior to uploading ?

can you post a picture of the gui showinf the reaction to stick position change from the rx ?

i suspect you did not set your imu/sensors

[Arakon]

Or the copter type was not set.

[Moraes]

Or escs problematics...

Today I have flashed blheli in 4 rctimer NFS30A, suplied with Simonk by rctimer. With Simonk this escs lost sinc with 5010 / 620kv and 4s.

One week passed thinking i have pid problems...

Solved replacing simonk by blheli...

1000 causes for one problem, its hard to discovery.


Sorry for my bad english.

Hugs,

JM