Parameters Lost during flight

[jevermeister]

Hi,

I started my Copter with my Aux 2 switch and throttled up.
All of a sudden it flipped, I disconnected the Lipo and restarted the FC and noticed there where no reaction while I tried to arm the motors,
I fired up my mobile and discovered that all PID parameters where 0 and all aux switches where delted?

WTF? what happend to the eeprom??
Nils


anyone noticed that before?

I use MWC 2.2

[haydent]

nope, maybe something with your board

[Hamburger]

Got close to any high power wireless devices or fields?

[jevermeister]

O. I could arm via switch on first try and seconds later everything was gone...

[Hamburger]

Multiple.profiles or no.flash.check enabled?

[CheeseBurger]

I have this problem sometimes.

[copterrichie]

I wonder if this system does IP Logging? Hmmmm.

[jevermeister]

Hey... Happened again. Maybe it is the Android tool from EZ...

[jevermeister]

I played around with the profiles but did not enable it in the code.

[Alexinparis]

Hey... Happened again. Maybe it is the Android tool from EZ...

With EZ gui, it is very important you make a read parameters before any write.
Otherwise, everything could be set to 0. I had also this problem once on the field.

[jevermeister]

Thank you Alex. I will keep an eye on that. And report back.

Nils

[Hamburger]

I have heard same cause from one other source so it is a good shot to watch this.

[alll]

Hey... Happened again. Maybe it is the Android tool from EZ...

Must be EZ,.. i had it once, luckily i had a saved copy!