NO SENSOR READINGS - CRIUS LITE - FLYING W

[Vautrin]

Hi

I got no sensor reading from my CRIUS LITE board set up with MW 2.1 for FLYING WING.
The software loaded though since the flying logo appeared on the bottom right of the GUI.
I get sensor reading commenting (//) the crius lite board option and uncommenting the gyro + acc MPU5030 (which are on that board) option but actions are wrong.
Any suggestion or should I replace that board with MW SE V2.0?

Thanks very much anyhow.

[Hamburger]

you may continue.
Use a magnifier (or the board description?) to identify the sensors on your board.
You are safe to define the sensors separately - should give readings for each sensor in gui;
then you must define the sensors orientations, there is info in wiki how to do that.
bingo.