MultiWii GUI

Version

2.0.1

Usage

• Download the current version from multiwii.com
• Unzip the file
• Open the config folder
• If you have windows choose the "Windows" folder and run the .exe file

Current issue

• Some computers have lag spikes
• Checkboxes sometimes won't turn on or off

ScreenShot

Communications

• V201: Displays the current version of the firmware on the board (When connected).
• SAVE: Save the current config to a file on disk.
• LOAD: Load the config from file.
• PORT COM: Select the COM port to use, to connect to the MultiWii over USB / FTDI.

Parameters / Settings

• PID Settings: Set the Global and Altitude PID.
• Expo Settings: Set the Expo and Rate settings for Throttle, or Pitch/Roll
• Calibration: Allows you to set the Magnetometer and Accelerometer calibration from the GCS.
• Read/Write: Reads/Writes the settings to/from the board.
• Feature Grid: Allows you to tie specific Flight Modes or sensors to Tx channels. To set a mode to "Always On", check all three boxes for that mode (Low, Medium and High).

Sensors / Debug

Output

Input

Visualization