Features:
• 7CH DSM2 Compatible Receiver (PPM SUM)
• Self-voltage checking
• FTD1 protection
• ATMEGA328P Microcontroller
• MPU6050 Accelerometer and Gyro
• BMP085 Digital Barometric Sensor
• HMC5883L Digital Manometer/Compass
• C8051F330 MCU
• CYRF69103 Radio
• Dual IIC Ports
• UART
• GPS Port (GPS not included)
• OLED Screen Port (OLED not included)
Can be bought at hobbyking. I plan to use it on a mini tri, i really like the specs and if everything works as advertised will be a great board.
It looks like the board can handle 2s directly on the motor outputs and it should be possible to power the esc directly from these pins if the current isn't too high. I know it might that the interference between this circuit and the sensors/atmega might be a problem but it would be a neat way to handle power distribution especially on small quads. Does anyone know how to wire up the default connections escs to this board? Combine the main power and ground connections with the signal line? There is a picture of a brushless esc with just a futaba plug herebut i couldn't find anything like that.
As soon as i get it and manage to find the right config i will post it here.