1.3" display support i2c OLED from digole.com

[Hamburger]

Just received and implemented support for a monochrome 1,3" display.
1.3" Serial: UART/I2C/SPI 128x64 OLED Module
From here http://www.digole.com/index.php?productID=550 or at e..y.

It is easier on my eyes and reduces memory footprint for my aio stand alone nanowii+oled controllers by about 750 bytes (compared to the other 0.96" OLED). It is similar to the other OLED but this one comes with included fonts-eeprom.

0.96" resolutions: 8x16 or 4x16
1.3 " resolutions: 7x21 or 5x16

For comparison I have added photos of both OLEDs, each with two different resolutions. For each configuration one photo of config.menu plus one photo of telemetry page 1.

Code is in r1413. Enjoy.

[dialfonzo]

Very interesting...
I have that board with i think is the same oled display.


HD Image
http://farm9.staticflickr.com/8117/8622193508_91843d14d9_o.jpg

Did you code anything to work ?

[Hamburger]

Sure. Like I wrote it is in _shared now.

[Carl334]

Digole display. Hamburger Did you have to use any code other than what in Multiwii 2.4. I can't seem to get it (the Oled) past the first screen. However have been able to implement the other OLED to work.

[Hamburger]

All my digole displays work out of the box with the MWii code.

[Carl334]

I guess I have a bad one never could get it to work. Thanks, Carl

[Hamburger]

Hold it.
When you power it up does it display its i2c address?
Did you solder the jumper to make it behave as an i2c device?