crius SE v2.0 Quad X problem with D11 connector

[4leafskull]

hello everyone,

i am a newbie to writting in forums and Multi wii quads.
Having read many pages and spent countless hours searching for an answer i find myself in need of help.
as per subject title, my quad X seems to have issues with the D11 connector.
during very low throttle and holding quad in the palm of my hand, when i tilt towards the back left corner no resistance is felt,
all other tilts are met with resistance. i have swapped motors and ESCs yet they all come back to that D11.
with my bluetooth module connected and v2.0 on laptop the D11 LHR motor shows an acceleration spike on screen when sudden LHR tilts are done to the quad, but the motor itself does not increase RPM.
during Yaw motions whilst held in palm, the motor responds rappidly and forcefully, is it possible that in the programming (where i can not seem to find)
that the Yaw vs Pitch and Roll configurations are somehow reversed ?

just one other thing, i have tried to move onto v2.1 and each time i have tried the software loads fine to the board and connects via bluetooth to my laptop however when using GUI there is no controls displayed on screen . . . . ? (throttle,pitch,roll or yaw . . . . so i switched back to v2.0)

i have purchased another board in despair and as i wait for its arrival

place this problem out there for anyone who has had the same or similar issues

and could find the time to help out a fellow Multi wii Quad copter enthusiast.

Thanks.

[Rainer]

Please, calibrate the Gyro and the ACC

[4leafskull]

It has been along time coming and am happy to report my new board
has resolved the problems i was having with the non responding D11 terminal.
All is well and i anticipate its maiden flight on the weekend.
Hopefully the cameras work and i will post some footage.

Cheers to all,

thanks for the 1 response.