Hi All .
I am confusing about this wiring. As the picture i attached below. Can anyone help me figure out about that.
First: We only need to use 4 wire (TX,RX,VCC, GND) to connect GPS module to Crius AIO Pro V2.0, or we NEED connect SCL and SDA to I2C port too???
Second: Can i use this GPS module for Crius AIO board? Because i hear that module use for APM, but on Crius only have 5V.
Please help me. Thank you so much!
Appreciate for any help!
Regard!
How To: wiring Neo GPS w/Compass to Crius AIOP V2
-
- Posts: 3
- Joined: Fri Jun 26, 2015 8:30 am
Re: How To: wiring Neo GPS w/Compass to Crius AIOP V2
If you only want to use GPS then you need to connect 5V, GND, RX and TX. The standard GPS pins on the Crius board are RX2 and TX2.
If you want to use the Compass on the GPS board then you will also need to connect SCL and SDA and disable the on-board compass on your Crius board.
Details here: http://www.multiwii.com/forum/viewtopic.php?f=6&t=6079
Leo
If you want to use the Compass on the GPS board then you will also need to connect SCL and SDA and disable the on-board compass on your Crius board.
Details here: http://www.multiwii.com/forum/viewtopic.php?f=6&t=6079
Leo
-
- Posts: 3
- Joined: Fri Jun 26, 2015 8:30 am
Re: How To: wiring Neo GPS w/Compass to Crius AIOP V2
Thank you Leo so so much. You saved my life. ^^
I just realized one way to connect them safety, i will post my way to share to everyone soon.
Thank You Leo again!!!
I just realized one way to connect them safety, i will post my way to share to everyone soon.
Thank You Leo again!!!