Hi Noctaro,
Thanks for your answer. Still got some problems however.
In my GUI i see the following.
When i USB-connect the Arduino to my computer (GUI) i can see that ACC is active.
![Exclamation :!:](./images/smilies/icon_exclaim.gif)
LiPo is NOT connected
But when i connect my LiPo (so receiver is also active) the ACC will turn itself OFF. (USB is still plugged in, so BOTH USB and LiPo are connected.)
I use the proportional channel 6 on my TX and the GUI shows values from 971-2100 on all four (AUX1-AUX2-CAM1-CAM2) at the same time
When i turn any Low Mid or High block on or off in the GUI, nothing happens.........and the ACC stays OFF.
Do you have any suggestions please?