Hi,
First of all, sorry for my bad english...
Any one knows witch of these options are the best for my quad?
40/50A Hk esc
Throttle setting options:
1 - Auto throttle range
2 - 1.1ms to 1.8ms (actual choice)
3 - Hard acc
4 - Soft acc
I'm having some random glitches with my actual config.
So I decided try tune the MIN_THROTTLE on code (to 1200), and did some adjusts on Tx ATV / end points to match the recomended Tx signal (1000 to 2000).
Now when i arm the quad the motors just start moving with the stick near of the center (+/- 1300). The stick on center i get +/- 1470.
Can you give me a little help here?
Thanks in advance,
Daniel
Esc options - Help please
Re: Esc options - Help please
I tried the option number 3 on the configuration of esc (Hard acc), did not notice any improvement in stability, however I noticed that all the quad vibrated in the air. I went to calibrate the esc's with option # 2, and now ... I'm waiting a little help or any tips.
P. S.: I did not see new glitches
P. S.: I did not see new glitches
Last edited by dfidalgo on Sat Nov 12, 2011 10:45 pm, edited 1 time in total.
- jevermeister
- Posts: 708
- Joined: Wed Jul 20, 2011 8:56 am
- Contact:
Re: Esc options - Help please
Hi,
50 Amps is quite much.
Get other ESCs.
I think these ESCs are not fast enough, the timing speed is too low for a multicopter.
They have to do a lot of controlling in very short time, I think 50A ESCs are made for boats or trucks unless you want to abduct sheeps and goats with your copter you should stick to lower amp ratios
50 Amps is quite much.
Get other ESCs.
I think these ESCs are not fast enough, the timing speed is too low for a multicopter.
They have to do a lot of controlling in very short time, I think 50A ESCs are made for boats or trucks unless you want to abduct sheeps and goats with your copter you should stick to lower amp ratios