Hamburger wrote:Try set MINCOMMAND 1008. I think that is used for initializing?
Thank you! That did the trick yes.
Hamburger wrote:Try set MINCOMMAND 1008. I think that is used for initializing?
ziss_dm wrote:Hi,
regards,
ziss_dm
1) Added possibility to adjust end-points using stick programming procedure (full throttle, power-up, wait for 2 beeps, throttle down, wait for long beep).
The question is which is the part that dyes that way? Is it user replacable?
IMHO: it looks like actual flash for ESC overwrites part of rootloader!?
Code: Select all
atmega8.bootloader.unlock_bits=0x3F
atmega8.bootloader.lock_bits=0x0F
crashlander wrote:Ups...
I had impression that when using WII-ESC-Flash tool it takes care of fuse (and other) bits.
But it seems not.
I guess/hope/persume that lockbits can be inverted (unlike reset disable)?!
Regards
Andrej
otti20vt wrote:Last Sunday i flash 4 ESC with Wiiesc and it looks like this firmware are slightly better then SimonK...
so removing smd caps is not an option.
the video i took was rx directly hooked up with esc
just want to smooth that lag out towards more linear... and instant..
I had impression that when using WII-ESC-Flash tool it takes care of fuse (and other) bits.
I'll try to use 3s batt... the vid is with 2s battery ... But compare to stock.. it is still a bit slower..
I'll get back here after tried with 3s