Just built this

Post Reply
Kbev5709
Posts: 451
Joined: Mon Aug 17, 2015 5:56 pm

Just built this

Post by Kbev5709 »

I just got done building this: https://www.youtube.com/watch?v=tARKHU3WEoo
https://www.youtube.com/watch?v=PF64RZmV2wI https://www.youtube.com/watch?v=X22iXrP9k_s I built the frame from scratch from square carbon fiber tube and flat CF sheet. I used a RTF Quads Multiwii Pro 2 FC, 4 20 amp RTF Quads Blue ESCs, a small PDB, a Turnigy 9x RX, 4-1000 Kv RTF Quads Red Special motors (made by Suppo) 9x4.5 props, and a 2,200 MAH 3s 35-70C LiPo. It is 250 mm from prop center to prop center.
Total cost of the build not counting the CF about $150.00
The CF I had sitting around for repair parts but the cost would total about $40.00 to buy from an Ebay vendor.
It's not that hard to build a frame from scratch. I used an angle grinder with a masonry cutting wheel to cut the CF and a drill and 6-32 stainless cap screws, stainless 6-32 washers and locking stainless nylon insert ESNA nuts to hold it all together. Use stainless hardware because it is non magnetic.

Kbev5709
Posts: 451
Joined: Mon Aug 17, 2015 5:56 pm

Re: Just built this

Post by Kbev5709 »

Got it flying. I've got this crazy i2c error though..... https://www.youtube.com/watch?v=fQflDGE ... e=youtu.be
it doesn't affect the flight any.

Post Reply