Hi,
updated in the past several times between the versions.
Never had problems.
Now Compiling and uploading 1.9 does not work.
Going to the conf connecting serial, Start, read, all numbers zero (P.I.D) and no RC rate line
Cycle field does not show Gyro lines, ...
Cannot arm, ...
Going back to 1.7 all works fine, ...
Tried these several times!
I have an Arduino Mini Pro and Original WMP
What can be wrong? Anyone an Idea?
cheers
Wolf
Update to 1_9 does not work
Re: Update to 1_9 does not work
If you have the very latest V1.9 (it has been silently patched a couple of times), and the GUI's debug2 window shows a number higher than 0, then you have I2C problems. A lot of discussion concerning how to fix this hardware issue is in the V1.9 release thread:
viewtopic.php?f=8&t=872
viewtopic.php?f=8&t=872
Re: Update to 1_9 does not work
Thanks a lot,
last version works now.
Cheers Wolf
last version works now.
Cheers Wolf
-
- Posts: 702
- Joined: Sun Aug 28, 2011 8:14 pm
- Contact:
Re: Update to 1_9 does not work
wss1 wrote:Hi,
updated in the past several times between the versions.
Never had problems.
Now Compiling and uploading 1.9 does not work.
Hi,
I´ve had the same problem when trying to use 1.7 code just to see the diference in stable mode.
Cheers,
Henrique