no usb connect until calibrating

This forum is dedicated to software development related to MultiWii.
It is not the right place to submit a setup problem.
Software download

no usb connect until calibrating

Postby dodecopter » Sun Feb 13, 2011 7:54 pm

hi,

connecting arduino nano to computer, it says : "unknown hardware"

but after calibrating the sensors, the arduino gets installed as usual

so you always need your Tx (for calibrating) if u want to connect the multiwii to pc.

i didnt notice this behavior in prior revision, is it a new "feature" in 1.6?
dodecopter
 
Posts: 35
Joined: Fri Jan 21, 2011 7:37 am

Re: no usb connect until calibrating

Postby spagoziak » Mon Feb 14, 2011 7:08 am

I haven't had this happen.. I can leave my tx off entirely and see what's going on in the config program. Can't calibrate, of course, but can still connect... I wonder why?
spagoziak
 
Posts: 171
Joined: Thu Jan 20, 2011 1:18 am


Return to Software development

Who is online

Users browsing this forum: No registered users and 11 guests

cron