vineetaquarius wrote:hi all this is the first time i am posting some thing on this forum , pardon me if i am over ruling this forum rule
guys please help
i have been trying to make gps works now , with different baud setting , but no luck yet
please advise what to edit
gnd - gnd
vcc - 5 volts
gps rx - aip pro v2.0 tx2
gps tx - rx2
aio pro v 2.0
u-Blox CN-06 GPS Receiver V2.0
now what is the correct baud rate and wiring please some body let me know who have got it worked
do i need ubox and ftdi also ? , i read some where that there is no need to set this gps as it is already configured.
ps : i am using v2 for both board and gps
please any body
I've got a similar issue with almost identical hardware. Set the GPS module via FTDI to 115200 and 10Hz, works fine with ucenter and gets a lock right away. When i plug into multiwiiconf, i can see the compass edge blinking indicating GPS frames are being received but it never acheives a lock when plugged into the copter. None of the GPS indicators in the GUI get any values. No blinking LEDS on FC either
Anyone have some pointers as to whats going on here? Im stumped!
Hardware is good and wiring seems ok as compass blinking but no lock ever. GPS module has had config saved to EEPROM and definately retains settings across power cycles as plug back into ucenter and get a fix right away.
Any pointers greatly appreciated!