mag calibration auto-stop?

rubadub · Post by **rubadub** » Tue Jan 06, 2015 3:24 am

Has any work been done on trying to setup the mag calibration routine to use a method that employs a 'stop detect' instead of a fixed,30sec timer? i.e., something that allows the user to keep rotating & calibrating the MAG sensor until a pause/timeout is detected. This would be helpful to allow user adequate time to fully rotate model, especially for large/clunky models.

ASAP · Post by **ASAP** » Sat Jan 17, 2015 11:23 pm