Nanowii uart communication

[TOURNEUR]

Hello everybody !

I had buy a Nanowii V01 ,here :
http://www.hobbyking.com/hobbyking/stor ... o_acc.html .

I will wish use it as an external gyro-accelerometer with uart communication .

I found the multiwii protocol ,and try use it with my nanowii card .

But nothing appears. Although, it work in multiwii GUI ... where I must select a com port .

The embeded chip Atmega32U4 is connect directly by usb but works with an virtual port com if I understand it correctly .

I send this simple frame request "MSP_IDENT":

$M<0100100 with com port tool ,and nothing appear .


I have a trouble with the baud rate which is not described in the protocol .
And is it the good protocol which i use ?


THank for your help