Hi everybody,
i dont know why, but the pin 5 of my crius AIOP seems to be dead. There is 4.3V at signal port (2.2V for the other port).
and i would like to know how to re- allocate the motor pin in multiwii 2.3?
i ve found this topic : viewtopic.php?f=8&t=5004
i try to use the same method for my case but that doesnt work !
(with my modif, i can see that the pin 5 is reallocated to pin 7 on multiwiiconf, but there is no signal at port 7...)
Thanks for your help
Mat
crius AIOP : pin 5 dead, how to re allocate?
-
- Posts: 3
- Joined: Thu Jun 05, 2014 8:50 pm
Re: crius AIOP : pin 5 dead, how to re allocate?
You can try what I described there.
Else
Programming required
Else
Buy new board
Btw. Wrong thread. Nothing to do with software development. Too late, answered already.
Else
Programming required
Else
Buy new board
Btw. Wrong thread. Nothing to do with software development. Too late, answered already.
crius AIOP : pin 5 dead, how to re allocate?
Have you checked for cold solder joints ?
-
- Posts: 3
- Joined: Thu Jun 05, 2014 8:50 pm
Re: crius AIOP : pin 5 dead, how to re allocate?
yes there is no cold solder at pin level, but i dont know at atmega level...
or somewhere else
i dont know where to see!
or somewhere else
i dont know where to see!
crius AIOP : pin 5 dead, how to re allocate?
I'm just throwing it out because one of my early frustrations with Multiwii were due to a cold solder pad of the micro controller.
Yours never worked or stopped working ?
Yours never worked or stopped working ?
Re: crius AIOP : pin 5 dead, how to re allocate?
http://www.rcgroups.com/forums/showthread.php?t=1420778&page=291#post28804615 describes how I mapped a (killed) pin 6 to use pin 8 on a MultiWiiCopter Paris board - I dare say you could do something analogous for pin 5 in the code for your board?