Sandrail wrote:i´m a little confused. is it possible to run 6 brushed motors on 328? if yes, would someone share his mwii sketch? i have build a nano spider hex with a pro mini
I'm also confused and would like to know too
My project is to use a Mini MWC board (328p from HK with DSM rx) to control the built-in brushed ESCs of another FC board (Revell Hexatron, 6X, 2S).
I'm actually a bit lost. This is what I did :
Soldered 1pin cables to the G leg of the 9926B MOSFETS (
http://aosmd.com/pdfs/datasheet/AO9926B.pdf).
Flashed the Mini MWC with 2.4.
Uncommented #define MINTHROTTLE 1050 // for brushed ESCs like ladybird
Uncommented and tried different values for #define EXT_MOTOR_xxKHZ
But I'm still getting nothing from the motors. The best I have is the motor buzzing with #define EXT_MOTOR_1KHZ
Also tested with the short made between the husban chip and the resistors before the Mosfet.
Dumb question because I'm new to MultiWii really: although I tested all ports on the FC, is it right to assume the motors number shown in the GUI match the numbers on the board?
I'm not sure what to do next and where to look at. I'm definitely lacking knowledge. I'm posting a pic of the Hexatron board on which I followed (unless wrong
) all the mosfets traces to the Husban chip which seems to handle everything.
Maybe cut all the traces feeding the husban chip? Any suggestion is welcome
I'd like to have at least have one motor run first before trying to have the Mini MWC run all 6 motors/ESCs which I believe according to a previous post is not yet possible with the current code.
Thank you!