Dear all-
due to the wish to connect my 3DR modules to do the tuning of PIDs the "nice way" I would need to change the GUI settings to 57600baud..
The MultiWiiWinGUI did support this change but it seems not to work with 2.2 (as could be expected I guess)- any way to change it in the MultiWiiConf_2_2.exe, too
I had a look at the source of the MultiWiiConf_2_2.exe and probably found what to change but I was not able to change it due to the "where should the library be now" fun... I copied the library to EVERY place that came to mind- still not works
Besides this 2.2 works awesome so far! THANKS
Roman
2.2 Gui working with 433 Mhz 3DR modules
-
- Posts: 44
- Joined: Wed Apr 25, 2012 11:21 pm
2.2 Gui working with 433 Mhz 3DR modules
Last edited by Quad FRITZ on Fri Mar 15, 2013 11:27 am, edited 1 time in total.
Re: Changing baud rate in 2.2 Gui for 3DR modules
Quad FRITZ wrote:Dear all-
due to the wish to connect my 3DR modules to do the tuning of PIDs the "nice way" I would need to change the GUI settings to 57600baud..
The MultiWiiWinGUI did support this change but it seems not to work with 2.2 (as could be expected I guess)- any way to change it in the MultiWiiConf_2_2.exe, too
I had a look at the source of the MultiWiiConf_2_2.exe and probably found what to change but I was not able to change it due to the "where should the library be now" fun... I copied the library to EVERY place that came to mind- still not works
Besides this 2.2 works awesome so far! THANKS
Roman
There is an update for MultiWiiWinGUI ... it works with 2.2
A
-
- Posts: 44
- Joined: Wed Apr 25, 2012 11:21 pm
2.2 with 3DR 433 Mhz telemetry: works
Due to the efforts of EOSBandi and all the programmers working on 2.2 it seems the new GUI works great with 2.2 via 433 Mhz, too.
My setup:
- CRIUS AIO Pro FC
- CRIUS V2 GPS
- 3DR 433 Mhz Modules (configuring them is pretty easy with the Megapirate SW)
- WinGUI2_2betaR37 via USB 3DR module set to 57600 baud
- MultiWii 2.2
First try it did not work properly (all PID values showed up as 0, could not arm copter any more) but after a new install of FC FW it worked great for me!
Thanks again!
Roman
My setup:
- CRIUS AIO Pro FC
- CRIUS V2 GPS
- 3DR 433 Mhz Modules (configuring them is pretty easy with the Megapirate SW)
- WinGUI2_2betaR37 via USB 3DR module set to 57600 baud
- MultiWii 2.2
First try it did not work properly (all PID values showed up as 0, could not arm copter any more) but after a new install of FC FW it worked great for me!
Thanks again!
Roman