Hi
Yesterday i tested to display the GPS coords in telemetry-mode.
The first digit of latitude is missing .i.e. latitude is real 52.0803977 and display is 208.03977
the point is also on the wrong place (logitude is also displayed wrong. divided by 100 it would be right)
I use an OLED display and uBlox serial GPS with mega 2560 (CRIUS AIO). Software is dev1317
can someone confirm this? how could this be fixed?
p.s. in config.h at line 789 i can define which pages are displayed in telemetry-mode. can someone add a text there (a comment would be fine) what is displayed at page 1,2,3,4,5,6,7,8,9 ? i.e. Page 1 = Sensor Display / Page 2 =.....
after this it would be easier to define the page of interest after stopping the automated hopping, the page would not be updated!
Thanks Michael
Telemetry GPS Display
Re: Telemetry GPS Display
update anyone?
Re: Telemetry GPS Display
Cannot believe that the problem should only exists with my configuration.
Re: Telemetry GPS Display
firmware of the GPS maybe?
Re: Telemetry GPS Display
hmmmm
its the ublox from flyduino (red board). dont know the firmware version. gps functions are working very well.
its the ublox from flyduino (red board). dont know the firmware version. gps functions are working very well.
Re: Telemetry GPS Display
do you have any other gui you can connect it to and verify?
Does the MWii gui provide same data but display it correctly?
Does the MWii gui provide same data but display it correctly?