Since the use of MultiWii 2.1, I have a strange behavior on my Quad X copter.
It seems that I have randomly an motor stop during the flight.
My last 3 flights have resulted in a flip and so on a crash
The strange behavior is that be produced with different function.
In my first fly after uploading and configuring the MultiWii 2.1 on my copter, I have a motor stop in accro fly after an POS HOLD. During this fly, I have setup the Level mode and tested it, I have made many test of POS HOLD (with LEVEL, BARO and MAG activated) and RTH (With LEVEL and BARO (I have forget to activate the MAG in MultiWII Conf)).
In my my second fly, I have tested the POS HOLD (with LEVEL, BARO and MAG activated) and RTH (With LEVEL, BARO and MAG). My motor was produced after an POS HOLD when I have activated the RTH Function
And Yesterday, my flip was produced during a smooth ACCRO fly.
Before, I used the MultiWII 2.0 with any problem but just in ACCRO Mode, LEVEL mode, MAG mode and HEAD FREE mode.
I want to use the MultiWII 2.1 because I have added an I2C GPS in my copter.
My Setup:
- FCWII
- Drotek IMU 10 DOF
- I2C GPS
- ESC Turnigy Plush 18A
- KEDA 20-28M
- Receiver FrSky D8R-II
- LIPO 3000maH 25C
Does anyone have this kind of problem?
I don't see what to do to try to solve it?
Finally, I want to thank all the contributor of the MultiWII Project. The last functionalies of MultiWII 2.1 is a real pleasure (POS HOLD, RTH, ALT mode is quite precise now).
And a real thanks to this forum, it allowed me to solve a lot of problem on my copter setup since 1 year.
Thanks
Frédéric