dev_20120528 and dev_20120504 does not connect
Posted: Sun Jun 03, 2012 8:11 pm
hi all,
I am a newbie. So sorry if this could be nonsense.
Having a 'ZMR MulitiWii SE' (CRIUS) board with the little FTDI USB board.
The MultiWiiConf_2_0.exe packed in MultiWii_2_0.zip works fine, I can connect
and read out PID etc. MAG and ACC are working too.
Using the dev_20120528 or the dev_20120504 shows not signal from the board.
Using the MultiWiiConf_2_0.exe packed in MultiWii_2_0.zip the TX and RX LED
blink nearly synchronous. Using the others dev versions named above, TX is
blinking but RX ist constantly on.
Any clues please ?
jedlesee
P.S. is there a simple way to read out what software version is loaded in the board?
I am a newbie. So sorry if this could be nonsense.
Having a 'ZMR MulitiWii SE' (CRIUS) board with the little FTDI USB board.
The MultiWiiConf_2_0.exe packed in MultiWii_2_0.zip works fine, I can connect
and read out PID etc. MAG and ACC are working too.
Using the dev_20120528 or the dev_20120504 shows not signal from the board.
Using the MultiWiiConf_2_0.exe packed in MultiWii_2_0.zip the TX and RX LED
blink nearly synchronous. Using the others dev versions named above, TX is
blinking but RX ist constantly on.
Any clues please ?
jedlesee
P.S. is there a simple way to read out what software version is loaded in the board?