Got most of the hardware togeather todat and most things works well.
I have no Roll or the mode change switch control avlible to me. its not showing up in the config gui anywhoo.
I have tried both 1.6 and 1.7 and no change, I can change the control inputs so things workish, is complocated i can unplug certain plugs and ill gain or lose channels or they will start mixxing....its not like servos when there unpluged they just dont go.
I find it rather odd that its channel 1 and 5 ( on the reciver) that are not working. the 2 channels at ether end of the range.
Im using a corona 2.4ghz transmitter unit and a matched 8 channel controler.
I double checked all my control wiering and even re solidered them all so they are all corect.
I only have one 2.4ghz radio, the rest are crystal radios and would rather stay with the 2.4ghz. I will try the crystal gear soon but rather have the 2.4 as stated.
I belive the problem lies ether in the radios ppm(?) or the way the software interpruts the servo inputs
Any ideas would be greatly appreciated.
No roll or mode change
Re: No roll or mode change
seems reciver needs to be grounded to the arduino.simaler issue was listed under another thread