in Screen.ino displayNumberOfSat, change
Code: Select all
if(!GPS_fix)
return;
to
Code: Select all
if(!GPS_fix && Blink2hz)
return;
I didn't test this, but should work.
Code: Select all
if(!GPS_fix)
return;
Code: Select all
if(!GPS_fix && Blink2hz)
return;
shikra wrote:Can you try the latest 1.1 in downloads
It compiles for me - but no idea if it works as not used that
Unless its a conflict with something else enabled in config.
shikra wrote:Can you try the latest 1.1 in downloads
It compiles for me - but no idea if it works as not used that
Unless its a conflict with something else enabled in config.
HFMan wrote:I'm getting a http 403 error trying to download R1.1- is there a permission problem on the web server?
ABL wrote:RSSI on frsky still does not work properly for me, but it's minor issue (i have voice telemetry, enough for basic warnings. I have ~5 steps from min to max, with 1.1/5V ref).
I made AHI elements wider/thicker (better visibility), everything else stays the same (thick fonts). If someone needs, font file attached.
Anyone used wider AHI (more symbols for AHI)?
Tort wrote:tested and working very well, good job.
i do have a question about the altitude, where does minimosd pull the altitude from? mine does not seem to display correctly, although it starts at 0 when i plug the battery in, when i take off alt starts to fluctuate and when i land osd shows anything from -1 to -3ft, now i am using an old multiwii pro board with 2.3 installed so im thinking that might me the issue but i haven't done any serious checking into it since i just noticed the issue last night
SecretSpy711 wrote:All of my GPS data is flashing / blinking, I can't figure out why. It didn't do this when I used the same GPS module (witespy house ublox v1) on a osd flashed with kv team firmware... any ideas what could be causing this?
do I need to enable //#define SERIAL_SPEED 115200 ?
or perhaps //#define FIXEDWING ?
PatrikE wrote:You only have 6 satellites when it's shown on the OSD.
It's not considered as Good fix until GPS_numSat >= 5 .
If you don't have FIX the GPS data is hidden.
I guess it's switching between 4-6 satellites.
HFMan wrote:2&3) You're right- duh! I'm using Baseflight, so I needed to enable that define.
HFMan wrote:4) When I turn off my UHF TX to check RSSI, RSSI drops down to near zero, then it jumps up to 100% and stays there.
SecretSpy711 wrote:I would rather #define MAPMODENORTH be enabled by default. Using takeoff direction as reference would really screw me up.
SecretSpy711 wrote:All of my GPS data is flashing / blinking, I can't figure out why. It didn't do this when I used the same GPS module (witespy house ublox v1) on a osd flashed with kv team firmware... any ideas what could be causing this? I have enabled //#define BASEFLIGHT in config.h.
I'm running MWOSD 1.1, and baseflight on a flip32+ with mixer set to flying_wing.
here's a sample:
do I need to enable //#define SERIAL_SPEED 115200 ?
or perhaps //#define FIXEDWING ?