Hi,
jpeti29 wrote:Don't know why, but the good value is 0.043 to show correct current values.
Another question. what can be the problem, if the bat1 value is always stay 0.0V? if i adjust the bat1 value in the menu, then it stays on that value forever.
For viewing bat1 voltage is necessary to allow VBAT monitoring in multiwii.
Your sensor (100A flytron) should work correctly with this modification:
Find readCurrent () routine and replace 'case 3:' with this code.
case 3:
currentValue *= 0.098;
break;
In the normal state there is blocked a correction of voltage so it dont work for you. (It works correctly only with 50A flytron sensor)
I will check this problem.
msev wrote:Is there maybe a function to change the thickness of the osd text?
At this time, this function isnt implemented.
Solutions for better visibility in direct sunlight (stronger background)
1. Remove resistor shown in Figure.
2. If it is still weak, change resistor for background with value about 20 ohm.
jpeti29 wrote:
Problem solved! nhadrian found the problem. The Bat1 value is coming from the mwc, bat2 value is from the wire which is connected to the osd.
thx Adrian!
Sorry, I was away from home at the weekend.
Deet wrote:Using release 7 final, do I need to uncomment anything in V2.1 to enable the feedback to the OSD or does it do all the polling for data itself?
Hi, there is not need to make any changes in multiwii configuration.