Please tell me.

Please tell me.

Postby watamako » Sat Jul 25, 2015 3:40 pm

How do it create a value of roll and pitch in a program,
put a switch on the aux?
Please tell me.
watamako
 
Posts: 9
Joined: Sat Jul 18, 2015 2:07 pm

Re: Please tell me.

Postby Cereal_Killer » Mon Jul 27, 2015 5:58 am

Why, the car is in the front yard, I'm sleeping with my clothes on...Sorry, couldnt resist.

What is it you want to do now? You want to see vehicle attitude roll and pitch or you want to see the stick commands? Either way what you have to do is connect to it with MSP (Multiwii Serial Protocol) and request the data. You can look at how MinimOSD or the MW GUI does it for the MSP it's self.
Last edited by Cereal_Killer on Mon Jul 27, 2015 4:15 pm, edited 2 times in total.
Cereal_Killer
 
Posts: 221
Joined: Fri Mar 06, 2015 5:44 am

Re: Please tell me.

Postby watamako » Mon Jul 27, 2015 9:54 am

I'd like to move multicopter like the following figure by a aux channel.
A use lever is only a aux channel.
Please tell someone to me.

Image
watamako
 
Posts: 9
Joined: Sat Jul 18, 2015 2:07 pm

Please tell me.

Postby vyizis » Mon Jul 27, 2015 9:58 am

You can't
vyizis
 
Posts: 4
Joined: Wed Aug 27, 2014 11:46 pm

Re: Please tell me.

Postby Cereal_Killer » Mon Jul 27, 2015 4:18 pm

vyizis wrote:You can't

He's right, you cant "move" the quad by sending AUX channel data.

What you can do is to setup a switch on your TX to send the stick commands to make a pre-defined movement, but that's all on the transmitter end, not in the quad's FC.

I still dont understand what your asking totally but like Vyizis says you cant control it over serial at all...
Cereal_Killer
 
Posts: 221
Joined: Fri Mar 06, 2015 5:44 am


Return to Ideas

Who is online

Users browsing this forum: No registered users and 2 guests

cron