Hello community,
is there already an implementation to use additional RC channels to transfer trim values directly to Multiwii?
I want to setup my trim switches on TX to act directly on conf.angleTrim[] variables. So trimming should be possible also in flight, without landing and stick configuration. I know, that I have to undock the trims in TX and set them to additional channels, but this is no problem on my OpenTx.
Best Regards!
Online trim during flight
Re: Online trim during flight
Hi!
As far as i know, until now this is only possible via bluetooth. I think it is handled by MSP (Multiwii Serial Protocol) messages. Maybe it would be possible if you set your additional channels to activate specific msp commands. But i am only guessing.
Greetz
As far as i know, until now this is only possible via bluetooth. I think it is handled by MSP (Multiwii Serial Protocol) messages. Maybe it would be possible if you set your additional channels to activate specific msp commands. But i am only guessing.
Greetz