Hello,
today connect nunchuck to the wmp. but it work very strange:
http://www.youtube.com/watch?v=g8258eRSe2o
work, then freeze with strange values and work again
try to change I2C_SPEED and INTERLEAVING_DELAY (2000/3000/4000) - the same problem =(
nunchuck freeze
-
- Posts: 1630
- Joined: Wed Jan 19, 2011 9:07 pm
Re: nunchuck freeze
It doesn't look like a freeze, but a permanent calibrating procedure. (full yaw left/full pitch backward/min throttle).
Do you have a RC connected ?
Do you have a RC connected ?
Re: nunchuck freeze
oops, sorry... i don't use ordinary RC (own control on other arduino+pc+web browser), start motor and all fine =) tnx