Arduino Nano Multiwii GPS Connection
Arduino Nano Multiwii GPS Connection
Hii,, i have built Multiwii Quadcopter with arduino nano and GY-87, it works. Now i want to adding GPS module. So, is possible if i connect the GPS module to multiwii with arduino nano?
Re: Arduino Nano Multiwii GPS Connection
Hai
I am starting with the same problem description. Currently studying the Multywii hardware and software.
My plan is to connect a Navspark GPS to a Arduno nano and a freeIMU version 4
I have found now two documents related to this subject. What I can see it is a good starting point:
https://www.rcgroups.com/forums/showthr ... d-Multiwii
https://www.dropbox.com/preview/Drone/m ... e=personal
I am new to this subject. I start using the Mulriwii because its simplisity. But the problem is that most people using more advanced flight controlers. But I like to lear how the flight controler is working and it seems to my that the Multiwii is a good starting point
My goal is to develop a GPS flight planner software for a airplane drone
John
I am starting with the same problem description. Currently studying the Multywii hardware and software.
My plan is to connect a Navspark GPS to a Arduno nano and a freeIMU version 4
I have found now two documents related to this subject. What I can see it is a good starting point:
https://www.rcgroups.com/forums/showthr ... d-Multiwii
https://www.dropbox.com/preview/Drone/m ... e=personal
I am new to this subject. I start using the Mulriwii because its simplisity. But the problem is that most people using more advanced flight controlers. But I like to lear how the flight controler is working and it seems to my that the Multiwii is a good starting point
My goal is to develop a GPS flight planner software for a airplane drone
John
Re: Arduino Nano Multiwii GPS Connection
Hello!
I would like to use a U-blox GPS module (GY-GPS6MV2)
To which pin to connect? (not with I2C converter)
What should I configure in MultiWii 2.4 config.h?
Laci
I would like to use a U-blox GPS module (GY-GPS6MV2)
To which pin to connect? (not with I2C converter)
What should I configure in MultiWii 2.4 config.h?
Laci
Re: Arduino Nano Multiwii GPS Connection
It sends serial data so setup like this.
#define GPS_SERIAL 1 // Or the serial port you have available
#define GPS_BAUD 57600 // Or 115200
#define UBLOX
#define GPS_SERIAL 1 // Or the serial port you have available
#define GPS_BAUD 57600 // Or 115200
#define UBLOX