Crius AIO Pro v2 motors showing power while not armed

Post Reply
NFAZ10
Posts: 3
Joined: Tue Mar 14, 2017 6:27 pm

Crius AIO Pro v2 motors showing power while not armed

Post by NFAZ10 »

Brand new build. Crius AIO pro V2 MW2.4.
When I am looking st my GUI it is showing that power is going to the motors if I throttle up all 4 values go up and they adjust as I tilt or move the quad with my hand. The motors are not physically getting signal. And the drone is not armed. Before this used to not show any activity on the motor outputs unless the quad was armed. Any ideas? I havnt tried to arm it yet as it it still being built.

juanquy
Posts: 30
Joined: Sat Jan 05, 2013 9:58 pm

Re: Crius AIO Pro v2 motors showing power while not armed

Post by juanquy »

Re calibrate ESC ?
Check if that channel is reverse on ur TX?
Check TX mid point is 1500 ?

no idea
I have the same board but I think I runningMW v2.3 or maybe v2.2

good luck with that.
JC

Post Reply