Crius AIO Pro v2 motors showing power while not armed
Posted: Tue Mar 14, 2017 7:37 pm
Brand new build. Crius AIO pro V2 MW2.4.
When I am looking st my GUI it is showing that power is going to the motors if I throttle up all 4 values go up and they adjust as I tilt or move the quad with my hand. The motors are not physically getting signal. And the drone is not armed. Before this used to not show any activity on the motor outputs unless the quad was armed. Any ideas? I havnt tried to arm it yet as it it still being built.
When I am looking st my GUI it is showing that power is going to the motors if I throttle up all 4 values go up and they adjust as I tilt or move the quad with my hand. The motors are not physically getting signal. And the drone is not armed. Before this used to not show any activity on the motor outputs unless the quad was armed. Any ideas? I havnt tried to arm it yet as it it still being built.