Crius AIO Pro v2 motors showing power while not armed

Crius AIO Pro v2 motors showing power while not armed

Postby NFAZ10 » Tue Mar 14, 2017 7:37 pm

Brand new build. Crius AIO pro V2 MW2.4.
When I am looking st my GUI it is showing that power is going to the motors if I throttle up all 4 values go up and they adjust as I tilt or move the quad with my hand. The motors are not physically getting signal. And the drone is not armed. Before this used to not show any activity on the motor outputs unless the quad was armed. Any ideas? I havnt tried to arm it yet as it it still being built.
NFAZ10
 
Posts: 3
Joined: Tue Mar 14, 2017 6:27 pm

Re: Crius AIO Pro v2 motors showing power while not armed

Postby juanquy » Fri Mar 17, 2017 6:01 am

Re calibrate ESC ?
Check if that channel is reverse on ur TX?
Check TX mid point is 1500 ?

no idea
I have the same board but I think I runningMW v2.3 or maybe v2.2

good luck with that.
JC
juanquy
 
Posts: 30
Joined: Sat Jan 05, 2013 9:58 pm


Return to Shields, boards and sensors

Who is online

Users browsing this forum: No registered users and 1 guest