Multiwii Lite v1 + GY-652

Post Reply
snbarry19
Posts: 6
Joined: Thu Jan 14, 2016 1:12 am

Multiwii Lite v1 + GY-652

Post by snbarry19 »

Hi all,

Hoping some kind soul and offer some advice here. I have a Multiwii Lite v1.0 FC board which I soldered up. I've now purchased a GY-652 breakout board (4-Axis Electronic Compass and Atmospheric Module BMP180 + HMC5983).

I was just about to begin soldering it onto the FC board this evening when I noticed that the marking on the PCB connectors between the MW board and GY-652 don't match (see attached picture).

Now, I don't know a huge amount about electronics but appears that the connection from MW FC -> GY-652 will be:

5V -> VIN
3V3 -> 3V3
GND -> GND
SCA -> SCL
SCL -> SCA

Is this OK or is there something else I need to be doing? Any advice would be greatly appreciated.

Steve
Attachments
DSC_0045.JPG

User avatar
Leo
Posts: 372
Joined: Wed Sep 17, 2014 7:01 am
Location: Germany
Contact:

Re: Multiwii Lite v1 + GY-652

Post by Leo »

Steve,

you will have to solder the GY to the MB with wires as follows:

5V -> VIN
OR
3V3 -> 3V3
AND
GND -> GND
AND
SDA -> SDA
AND
SCL -> SCL

Leo

snbarry19
Posts: 6
Joined: Thu Jan 14, 2016 1:12 am

Re: Multiwii Lite v1 + GY-652

Post by snbarry19 »

Thanks for the response Leo! I figured as much.

Post Reply