how to connect gps module to arduino uno with multiwii 2.4

how to connect gps module to arduino uno with multiwii 2.4

Postby stefno11 » Wed Nov 16, 2016 5:49 pm

How to connect GPS UBLOX NEO-6M to Arduino one for the proper functioning of MultiWii 2.4?
stefno11
 
Posts: 4
Joined: Thu Oct 06, 2016 11:42 am

Re: how to connect gps module to arduino uno with multiwii 2

Postby Kbev5709 » Thu Nov 17, 2016 3:41 am

stefno11 wrote:How to connect GPS UBLOX NEO-6M to Arduino one for the proper functioning of MultiWii 2.4?

Arduino Uno uses the 328P processor which lacks the required memory to run anything more than minimal GPS (and still probably won't even work minimally.) A better bet if you insist on using arduino would be an arduino mega.
Kbev5709
 
Posts: 451
Joined: Mon Aug 17, 2015 5:56 pm

Re: how to connect gps module to arduino uno with multiwii 2

Postby stefno11 » Thu Nov 17, 2016 11:54 am

thanks, on Arduino mega where is connected the GPS module?
stefno11
 
Posts: 4
Joined: Thu Oct 06, 2016 11:42 am

Re: how to connect gps module to arduino uno with multiwii 2

Postby Kbev5709 » Thu Nov 17, 2016 2:37 pm

stefno11 wrote:thanks, on Arduino mega where is connected the GPS module?

I have no idea. I don't use an arduino uno or mega. Never tried to use one and never would. Too many wires needed. It makes a mess. I'm sure others have done it and there is info out there if you look. Try YouTube.
Kbev5709
 
Posts: 451
Joined: Mon Aug 17, 2015 5:56 pm

Re: how to connect gps module to arduino uno with multiwii 2

Postby handsomejackuk » Wed Dec 21, 2016 1:26 pm

I did get atmega 328p running gps a while back i used a home built serial to i2c convertor for the GPS to work... although the GPS was working i never got any gps functions to work... it did read the GPS and show position
handsomejackuk
 
Posts: 97
Joined: Mon Sep 08, 2014 12:25 am

Re: how to connect gps module to arduino uno with multiwii 2

Postby Kbev5709 » Wed Dec 21, 2016 3:02 pm

handsomejackuk wrote:I did get atmega 328p running gps a while back i used a home built serial to i2c convertor for the GPS to work... although the GPS was working i never got any gps functions to work... it did read the GPS and show position

Yep. That's about all you can get out of GPS with a 328P. So, if you can't make it do at least a RTH or GPS hold, it's basically not working.
Kbev5709
 
Posts: 451
Joined: Mon Aug 17, 2015 5:56 pm


Return to Shields, boards and sensors

Who is online

Users browsing this forum: No registered users and 1 guest

cron