Page 1 of 1

MW + ATmega328 = coaxial drone?

PostPosted: Sun Oct 23, 2016 12:19 pm
by Rumcajs
I'm sorry but I use a translator..
Are Multiwii for ATmega328 can control a drone in the system coaxial ?

Re: MW + ATmega328 = coaxial drone?

PostPosted: Sun Oct 23, 2016 9:36 pm
by PatrikE
Should be possible to use the Dual Copter Mix.

Re: MW + ATmega328 = coaxial drone?

PostPosted: Sun Oct 23, 2016 10:03 pm
by Rumcajs
On the logic just as much thought, but I wanted to make sure ;)

Re: MW + ATmega328 = coaxial drone?

PostPosted: Mon Oct 24, 2016 7:41 am
by PatrikE
Maybe not plug n play but it's something to start with.

Re: MW + ATmega328 = coaxial drone?

PostPosted: Mon Oct 24, 2016 2:22 pm
by Rumcajs
I know that the models are flying in the MW, but I think for the version with a large ATmega.

Re: MW + ATmega328 = coaxial drone?

PostPosted: Mon Oct 24, 2016 2:48 pm
by PatrikE
A 328 will be good enough until you start adding GPS etc.
Then it will be short of memory.
But you can easily config the setup and test to compile in Arduino ide to get a Idé of sketch size.

Re: MW + ATmega328 = coaxial drone?

PostPosted: Mon Oct 24, 2016 4:56 pm
by Rumcajs
Yes, I know - I have quadcopter and I have no problems with the settings in the config, but I prefer to avoid changing FC ;)

Re: MW + ATmega328 = coaxial drone?

PostPosted: Sat Nov 12, 2016 11:07 am
by Hamburger
interesting design.
from that drawing it is not entirely clear how steering works - two servos to tilt the entire motor+props drive train?
You will likely face similar challenge to dualcopter: no fixed reference point for tilting the propeller plane against. Most dualcopters use some kind of stabilizer fins to reduce counter movement of the body.
good luck and keep us updated. We could help you with the mixing code if needed

Re: MW + ATmega328 = coaxial drone?

PostPosted: Thu Dec 08, 2016 9:43 pm
by Rumcajs
I'm sorry - here a long time yet to look ..
Yes, engines and propellers work as HERE (I use a translator, and I can not properly be called ..)
Thank you for your offer of help - would definitely use : D

Re: MW + ATmega328 = coaxial drone?

PostPosted: Mon Dec 19, 2016 7:26 am
by Rumcajs
The elements are printed on a printer 3D, so more in a new thread :)