What the heck is this
static const float _filter = 7.9577e-3; // Set to "1 / ( 2 * PI * f_cut )";
trying to set up an i2c gps and multiwii
windows 10
UBLOX 6
arduino fresh download
i2c to gps board eprom cleared and the blink sketch installed so i know the board works.
i keep getting this error highlighted in the arduino IDE
static const float _filter = 7.9577e-3; // Set to "1 / ( 2 * PI * f_cut )";
any thoughts on a remedy??
i2C GPS NEO-6 WEIRD ERROR Message
-
- Posts: 103
- Joined: Fri Dec 12, 2014 5:16 pm
Re: i2C GPS NEO-6 WEIRD ERROR Message
signal filter at 20Hz?
I've got ublox with i2c gps nav and it works perfectly fine
I've got ublox with i2c gps nav and it works perfectly fine
-
- Posts: 4
- Joined: Sun Apr 17, 2016 2:05 pm
Re: i2C GPS NEO-6 WEIRD ERROR Message
is this in i2c gps or multiwii????
-
- Posts: 103
- Joined: Fri Dec 12, 2014 5:16 pm
Re: i2C GPS NEO-6 WEIRD ERROR Message
it's serial gps connected to multiwii using i2c gps nav
Re: i2C GPS NEO-6 WEIRD ERROR Message
Try to remove "const"
-
- Posts: 103
- Joined: Fri Dec 12, 2014 5:16 pm
Re: i2C GPS NEO-6 WEIRD ERROR Message
why would I want to do so?
Re: i2C GPS NEO-6 WEIRD ERROR Message
gregd72002 wrote:why would I want to do so?
Actually you need to remove
static const
and leave
Code: Select all
float _filter = 7.9577e-3; // Set to "1 / ( 2 * PI * f_cut )";
Because newer Arduino IDE does not support it like older did.
Or downgrade the Arduino IDE.
-
- Posts: 4
- Joined: Sun Apr 17, 2016 2:05 pm
Re: i2C GPS NEO-6 WEIRD ERROR Message
YOU ARE A GOD!!
in the multiwii world
Thank You
in the multiwii world
Thank You