Page 1 of 1

Crius Multiwii se v2.5 fried!!!

PostPosted: Sat Oct 24, 2015 8:56 pm
by Ciki
Hi. I was calibrating compass of my quad and fc was connected to pc with ftdi. After few seconds i saw a little point of fire on the board and a smoke. I disconnected the usb cable and reconnect the fc but it wasn't recognized anymore. Status green led turned on and off moving the board while it was solid light before. This is a photo of the board indicating the component fried in the red circle:
20151024_214954-768x795.jpg


Which is this component? Is it possible to repair?
Thanks!!!!