query about a product
Posted: Fri Sep 18, 2015 7:58 am
hello all ,
I am trying to replicate the PCB design shown as an image in the below link. I have looked at the device datasheet and understand the device itself fairly well. However I have never done any high power PCBs before and needed to know are there any special things that I have to account for when designing PCB that can handle 10A or so currents. I read something about impedance controlled PCBs etc, do I need those for this? Also where can I get such PCBs made in the US, at a lower cost.
http://www.ensembletech.in/portfolio-items/prototyping-dual-h-bridge-drive-for-under-water-rov/
I am trying to replicate the PCB design shown as an image in the below link. I have looked at the device datasheet and understand the device itself fairly well. However I have never done any high power PCBs before and needed to know are there any special things that I have to account for when designing PCB that can handle 10A or so currents. I read something about impedance controlled PCBs etc, do I need those for this? Also where can I get such PCBs made in the US, at a lower cost.
http://www.ensembletech.in/portfolio-items/prototyping-dual-h-bridge-drive-for-under-water-rov/