Page 1 of 1

Servos won't moving

PostPosted: Wed Sep 02, 2015 8:37 pm
by TOURNEUR
Hi

I wish ,i want to use my nanowii as a gimbal camera with servo control ,uniquely.

I configured my nanowii with arduino gui and defined the appropriate lines for have a gimbal control and stabilisation ,with a ppm control from my receiver .

In Multiwii gui ,I see ppm input ,accelerometer sensor moving ,but servo stay in neutral mode ,although I changed the definition lines ,and read a lot of of times .

But always my servo stay on neutral position and not work .



For Gimbal , Nanowii ,and ppm input


Thanks for any help