Servos won't moving

Servos won't moving

Postby TOURNEUR » Wed Sep 02, 2015 8:37 pm

Hi

I wish ,i want to use my nanowii as a gimbal camera with servo control ,uniquely.

I configured my nanowii with arduino gui and defined the appropriate lines for have a gimbal control and stabilisation ,with a ppm control from my receiver .

In Multiwii gui ,I see ppm input ,accelerometer sensor moving ,but servo stay in neutral mode ,although I changed the definition lines ,and read a lot of of times .

But always my servo stay on neutral position and not work .



For Gimbal , Nanowii ,and ppm input


Thanks for any help
Attachments
Config file.zip
(1.11 KiB) Downloaded 37 times
Nanowii with no servo output working.PNG
TOURNEUR
 
Posts: 5
Joined: Sun Sep 28, 2014 3:00 pm

Return to Shields, boards and sensors

Who is online

Users browsing this forum: No registered users and 4 guests