HI everybody
I have buyed a 'hextronik nanowii v01' for a specific use for underwater rov.
I would like to use the ppm signal to control my servos through the nanowii module .
When i connect my ppm sum signal on the module, I see the 6 virtual servos on 'Multiwiiwin gui' which moving.
But when i disconnect it from my computer to use it in standalone no pwm signal appear on the servos ports .
The ppm sum function is it normally deactivate ,when we buy one for the first time ?
Could I activate this ppm function through Multiwiiwin gui ?
Or do I need realy use arduino gui with a new multiwii firmware modified ?
Thanks for any help
PPM sum activation ?
Re: PPM sum activation ?
Yes, PPM Sum can only be activated during compiling. So you will have to modify config.h in the source code and flash the modified firmware.
Re: PPM sum activation ?
Hi ,Lutzb
In first, many apologize, for my late reply to your reply .
Ok , now i understand more why certain functionality don't work.
Now ,i need to understand how I need to program the multiwii, on arduino ide...
Thanks for your reply Lutzb
In first, many apologize, for my late reply to your reply .
Ok , now i understand more why certain functionality don't work.
Now ,i need to understand how I need to program the multiwii, on arduino ide...
Thanks for your reply Lutzb
Re: PPM sum activation ?
Hi ,
I had entering in the config.h mode of multiwii and selected ppm sum .
But I obtain a fixed square signal, on all servos ports not a pwm signal ,proper to control any servos .
I asked myself ,if it possible to configure a nanowii as a very simple ppm sum to servos controler .
Because, the multiwii boards where built to control esc motor ,start with a minimum throttle ...
But can we configured this board like my desired configuration....
Thanks
I had entering in the config.h mode of multiwii and selected ppm sum .
But I obtain a fixed square signal, on all servos ports not a pwm signal ,proper to control any servos .
I asked myself ,if it possible to configure a nanowii as a very simple ppm sum to servos controler .
Because, the multiwii boards where built to control esc motor ,start with a minimum throttle ...
But can we configured this board like my desired configuration....
Thanks