Reset HK MicroWii 32U4
Posted: Sat Aug 08, 2015 9:27 am
Hi guys,
a few month ago I started this topic: http://www.multiwii.com/forum/viewtopic.php?f=8&t=6202&p=62306#p62306
I changed and uploaded the new code, but after that my board wasnt recognized by my computer so ther is probably a logical mistake in it. I bought a new board and everything was fine, but now I've acidentally seen that there is an reset pin on the original MicroWii from flyduino
Image
(Manual: http://flyduino.net/documents/microWii_Manual_Rev0r2.pdf).
I found the same pins on my HobbyKing MicroWii Image
(Manual: http://www.hobbyking.com/hobbyking/store/uploads/741171780X846863X13.pdf).
But they arent labelled. Now my question is how the pin layout is at this six pins and how I have to connect which pins in which way.
Thank you!
a few month ago I started this topic: http://www.multiwii.com/forum/viewtopic.php?f=8&t=6202&p=62306#p62306
I changed and uploaded the new code, but after that my board wasnt recognized by my computer so ther is probably a logical mistake in it. I bought a new board and everything was fine, but now I've acidentally seen that there is an reset pin on the original MicroWii from flyduino
Image
(Manual: http://flyduino.net/documents/microWii_Manual_Rev0r2.pdf).
I found the same pins on my HobbyKing MicroWii Image
(Manual: http://www.hobbyking.com/hobbyking/store/uploads/741171780X846863X13.pdf).
But they arent labelled. Now my question is how the pin layout is at this six pins and how I have to connect which pins in which way.
Thank you!