Naze32 Board Reciever Error

Naze32 Board Reciever Error

Postby xwhyz » Tue Jul 14, 2015 6:42 am

Currently I own three Naze32 boards all flashed with clean flight 1.7.1 and 1 works perfectly(on my tri and h quad builds). The other two units on the same platforms both cannot receive inputs from certain channels on the receiver. I'm using a six channel ORX receiver with an ORX T-6 transmitter. On the second board I ordered the elevator(ch2) input does not show an input on the Naze32. On the replacement board the elevator,throttle, pitch, and roll do not work. I don't know if I have a faulty unit or somethings wrong with the channel map or firmware.
xwhyz
 
Posts: 1
Joined: Tue Jul 14, 2015 6:25 am

Return to Shields, boards and sensors

Who is online

Users browsing this forum: No registered users and 1 guest

cron