How To: wiring Neo GPS w/Compass to Crius AIOP V2

How To: wiring Neo GPS w/Compass to Crius AIOP V2

Postby khaidang27 » Fri Jun 26, 2015 8:38 am

Hi All .
I am confusing about this wiring. As the picture i attached below. Can anyone help me figure out about that.
First: We only need to use 4 wire (TX,RX,VCC, GND) to connect GPS module to Crius AIO Pro V2.0, or we NEED connect SCL and SDA to I2C port too???
Second: Can i use this GPS module for Crius AIO board? Because i hear that module use for APM, but on Crius only have 5V.
Please help me. Thank you so much!

Appreciate for any help!
Regard!
Attachments
crius-layout.jpg
khaidang27
 
Posts: 3
Joined: Fri Jun 26, 2015 8:30 am

Re: How To: wiring Neo GPS w/Compass to Crius AIOP V2

Postby Leo » Fri Jun 26, 2015 12:53 pm

If you only want to use GPS then you need to connect 5V, GND, RX and TX. The standard GPS pins on the Crius board are RX2 and TX2.

If you want to use the Compass on the GPS board then you will also need to connect SCL and SDA and disable the on-board compass on your Crius board.
Details here: http://www.multiwii.com/forum/viewtopic.php?f=6&t=6079

Leo
User avatar
Leo
 
Posts: 372
Joined: Wed Sep 17, 2014 7:01 am
Location: Germany

Re: How To: wiring Neo GPS w/Compass to Crius AIOP V2

Postby khaidang27 » Mon Jun 29, 2015 7:08 pm

Thank you Leo so so much. You saved my life. ^^
I just realized one way to connect them safety, i will post my way to share to everyone soon.
Thank You Leo again!!!
khaidang27
 
Posts: 3
Joined: Fri Jun 26, 2015 8:30 am


Return to Shields, boards and sensors

Who is online

Users browsing this forum: Exabot [Bot] and 2 guests

cron