Motor won't start

Post Reply
Rb3
Posts: 2
Joined: Fri May 01, 2015 6:33 pm

Motor won't start

Post by Rb3 »

i have a problem with my Qaudcopter. I'm building my first quadcopter.
Now i have done all the steps. But the motor won't start.

- Firmware multiwii 2.3 on my multiwii pro uploaded. (with the good setting)
- Calibrate the esc (so without the multwii pro the motor and the esc's are working)
- I checked all the connections to the receiver and they all connected to the good pins.
- When i put the battery on all the esc's are armed and i getting a green light on the esc's.
- On the multiwii pro there is blinking a red led and the green led.
- On the multiwii wiki i saw that you can stop the motor. So i followed the instructions: throttle down and rudder to the right to start the motor. I see that the red light on the multiwii pro is 1 sec. stopping with blinking en then he blinks again.

Have someone a idea why the motor's won't start when i move the throttle up?

waltr
Posts: 733
Joined: Wed Jan 22, 2014 3:21 pm
Location: Near Philadelphia, Pennsyvania, USA

Re: Motor won't start

Post by waltr »

Did you cal the ACC in the GUI??
Are the TX's Stick end points correctly setup in the TX menu?
Did you read the MultiWii WIKI, beginner's troubleshooting?

Rb3
Posts: 2
Joined: Fri May 01, 2015 6:33 pm

Re: Motor won't start

Post by Rb3 »

Sorry, it already working.
I need to have more patience, after 2 min the red light was going out.
unlock the motor and everting is working fine!.

Post Reply